ST AD-ICD/DS8Z-01, Руководство пользователя, Страница: 7 / 15

AD-ICD 3 Connecting to the application board
7/15
3 Connecting to the application board
This chapter describes the physical connection of the ICD adapter to your in-circuit
debugging tool and to your application board.
Note: The DB715 flexible and associated on-application connectors for the DFN8 package are
delivered with the ST7MDT10-8/DVP connection kit (see
Delivery checklist ).
The following sections show connection illustrations for each supported package type:
●
Connection for DIP8 microcontroller package on page 8
● Connection for SO8 microcontroller package on page 9
●
Connection for DFN8 microcontroller package on page 10
Figure 6. Connectors on the ICD Adapter
The ICD Adapter (MB509) connects to
your in-circuit debugging tool via the
10-pin ICC connector on the top of the
adapter. It connects to the connector
installed on you application board via
an 8-pin connector on the bottom of
the adapter (see
Figure 6
).
To use the ICD Adapter you will have
to solder the appropriate package
specific connector to your application
board in place of your target
ST7LiteUS microcontroller.
Table 2
shows the available connectors
Table 2. Target MCU packages and their application connectors
Package ICD Adapter Application board connector(s)
DIP8 MB509 DB646
SO8 MB509 SO8, 8-pin connector
DFN8 MB509 DB715 flexible adapter
10-pin ICC connector
8-pin connector
Top
Bottom