3 Connecting to the application board
AD-ICD
10/15
3.3
Connection for DFN8 microcontroller package
1.
Solder the DFN8 female connector onto your application board in place of your
microcontroller.
2.
Plug the ICC cable from the in-circuit debugging tool into the 10-pin ICC connector on
the top of the ICD Adapter (MB509).
3.
Plug the 8 pins of the DFN8 Device adapter (DB715) into the 8-pin connector on the
bottom of the ICD Adapter (MB509).
4.
Connect the DFN8 Device adapter (DB715) to the DFN female connector on your
application board using the DFN male-male connector. Because of the position of the
GND pin on these connectors, there is only one way to connect them together (see
detail in
).
Figure 9.
DFN8 connection scheme
Pin 1 indicators
ICC cable
Application board
DFN8 Device
Adapter (DB715)
ICD Adapter
(MB509)
10-pin ICC
Connector
GND pin
DFN8 female
connector
DFN8 male-male
connector