Greenfield Installation and Operations Stove
Page 28
program or read the instructions on the following page. The unit is set to the default program,
which is program 1. There is no feature to check to see which program is running. You must
change it to see what program was running and then cycle back through the programs to revert to
program 1.
The Cycle time is the total of the ON Time & OFF Time added together. The ON Times are
constant, so this means that the OFF Time is increased or decreased, depending on the program
chosen.
Program 1.
The Cycle Time is 11.5 seconds. This is the default program when the Greenfield is
first plugged in. This program does not offer self-ignition.
This program is for use with
Corn,
Wheat and Rye, Cherry Pits & Distillers Grain.
Program 2.
The Cycle Time is 13 seconds. This program does not offer self-ignition.
This
program is for use with
Corn, Wheat and Rye, Cherry Pits & Distillers Grain.
Program 2 is for adjusting for variations that occur within the approved fuels for this unit. Ask
your dealer before using this Program in your unit. Program 2 is for “Tweaking” the unit for
different fuel and installation conditions.
Program 3.
The Cycle Time is 11.5 seconds. THIS PROGRAM IS ONLY TO BE USED WITH
THE PRESCOTT EXP AND PRESCOTT EXL MODEL.
(DO NOT USE THIS PROGRAM
WITH THE GREENFIELD).
Program 4.
The Cycle Time is 10 seconds. THIS PROGRAM IS ONLY TO BE USED WITH
THE PRESCOTT EXP AND PRESCOTT EXL MODEL.
(DO NOT USE THIS PROGRAM
WITH THE GREENFIELD).
Changing the program on the Control Board
To change the program the Stove must be in the OFF
position, the unit must be cooled down so the Proof of Fire
disc is open and the Thermostat Slide Switch must be in the
Manual mode.
(See figure 19)
Press & hold
the Auger Feed Button, then press the Trim
High & Low
Button at the same time. The 5 LED lights that
indicate the heat levels will flash. The number of times the
lights Flash will indicate which program is running.
Program 1 – LED lights flash
once
Program 2 – LED lights flash
twice
Program 3 –LED lights flash
three times
Program 4 –LED lights flash
four times
Figure 19