P52110_MXXXXX_Jan2020
PAGE 10
OPERATING INSTRUCTIONS
Before filling hopper, become familiar with the operation of this spreader.
1.
Obtain proper setting for material to be used
from the enclosed SETTING MATRIX included
with this spreader, or from our web site under
the MANUALS SECTION.
2.
Move stop bolt on rate gauge assembly to the
proper setting.
3.
While pushing spreader forward, pull control
lever back to stop bolt.
4.
To stop, push lever forward to close flow holes
before you stop moving.
5.
When finished, empty any remaining material
from hopper.
6.
Thoroughly wash spreader and allow to dry before
storing. A coating of light oil will help prevent corrosion.
7.
Keep this manual for future reference
CUSTOMER SERVICE
574.848.7491
| [email protected] | WWW.EARTHWAY.COM
RATE SETTING MATRIX
The settings furnished on the Rate Setting Matrix are
intended as a guide only. Variations in physical charac-
teristics of material applied, walking speed, and rough-
ness of ground surface may require slightly different
spreader settings. Due to the above conditions, the
manufacturer makes no warranty as to the uniformity
of coverage actually obtained from the settings listed.
HOW TO ORDER SPARE PARTS
All spare parts listed herein may be ordered direct from
the manufacturer. Be sure to give the following infor-
mation when ordering. (Model Number, Part Number,
Part Description)
EARTHWAY SIDE SPREAD CONTROL TECHNOLOGY OPERATION
The
EARTHWAY SIDE SPREAD CONTROL TECHNOLOGY
lever is located on the back of the hopper at the bottom. To
operate the
EARTHWAY SIDE SPREAD CONTROL TECHNOLOGY
, slide the control lever from the left, to the right. This
will activate the
EARTHWAY SIDE SPREAD CONTROL TECHNOLOGY
for a Partial spread pattern and prevent material
from being spread to the left side of the spreader. Position the left wheel of your spreader 12”-16” from the sidewalk,
flowerbed, or driveway and spread as normal. When you have completed this spreading pass, open the
EARTHWAY
SIDE SPREAD CONTROL TECHNOLOGY
by sliding the control lever from right to left, for a
FULL
spread pattern.
1-YEAR LIMITED WARRANTY
EPI. warrants this product free of defects in original workmanship and materials for a period of 1-year to the end user with
the original purchase receipt. If a manufacturing non-conformance is found, EPI. at its discretion will repair or replace the
part(s) or product at no charge provided the failure is not the result of incorrect installation, mishandling, misuse, tamper-
ing, or normal wear and tear as determined by EPI. EPI. at its discretion may require that the part(s) or product be returned
along with the original purchase receipt at owners’ expense for examination and compliance with the terms of this warran-
ty. Do not return any product without first receiving authorization from EPI. To seek remedy under this warranty, contact
EPI. at 574-848-7491, [email protected] or write to EPI. 1009 Maple St., Bristol, Indiana 46507 and describe the na-
ture of the manufactur defect. SPECIFIC LIMITATIONS: This warranty covers only the part(s) or product; any labor charges
associated with repair or replacement of non-conformances are specifically excluded. Due to the corrosive nature of most
fertilizers and ice melt products, EPI.. makes no warranty against and specifically excludes part(s) or product degradation or
failure due to corrosion or its effects, or the use of powdered materials. Clean and dry your spreader thoroughly after each
use, as a preventative measure, coat all metal parts with a light oil or silicon spray.
