( 5 / 8)
DMX signal controlled projector shutter:
When power adaptor and the DMX line have been connected, the projector shutter is ready
for use. By changing the percentage of the chosen DMX address, the motor axle can be
turned forward and backward according to the DMX percentage. The motor axle can turn
from 0 to 90 degrees, 0% meaning 0 degrees and 100% being 90 degrees. The mirror
movement of the flap can be achieved by setting of the switch #10 near the DMX address
selector marked as TEST.
Switch controlled projector shutter:
The shutter with the DMX interface has an optional switch button. Projector shutter can be
controlled by a short circuit of the DMX lines 1 and 3 on the DMX cable. In this case, the
DMX OK and DMX ERR LEDs are on. This signalizes that shutter’s flap is closed – it is in 90-
degree position. The movement can be inverted by the TEST switch #10.
USB controlled projector shutter:
DMX 1-512 projector shutter can also be controlled by
the DMX. To control it, the DMX SW-UPG cable and software is needed. Ask us for the USB
support.
