SRS Light Design s.r.o
, Rybničná 36/D , 831 06 Bratislava, Slovak Republic tel:+421244681417,
fax:+421244681419,
www.srslight.com
,
Front panel:
Rear panel:
Device in use / service:
By default, Power LED indicates the device is on main power. When the Power LED is off,
check the main power input. When this does not solve the problem, please call service
first and then open DSTS4 and check fuses on the main board.
When the DMX cable is connected to the device, LEDs marked as D+ and D- go on for the
side marked as DMX input, thru and this indicates that DSTS4 is receiving the DMX signal.
Speed of light on these LEDs also indicates the refresh rate of DMX signal. Fast blinking –
high refresh rate, slow blinking – slow refresh rate.
On the rear panel of DSTS4, there are outputs A-D, which are retransmitting the input to
the optically isolated outputs. If any of data LEDs is off, unplug the signal cable
corresponding to this output and check the cable for short circuit between D+ and CMN or
D- and CMD lines.
