Stanford Research Systems
UGA Series Universal Gas Analyzers
Quick Start
x
• Unscrew the Ultra-Torr fitting and remove the pin (see photo).
• Use the pin holder to the right to store the pin.
• Insert your capillary into the Ultra-Torr fitting and tighten.
• Replace the panel.
• Insert the UGA/RGA software CD into your PC and follow the
prompts to install the UGA and RGA control software.
• Power up the UGA if it is off.
• Setup Ethernet paramters (IP address, Subnet Mask, Gateway,
Username, and Password) properly at UGA. Please refer to the sec
-
tion 2.3.3.1 of this manual for detailed information.
• Connect the provided Ethernet cable between the UGA and a
switch or a router which your PC is connected. If your PC is not
connected to Ethernet, then use Serial connection instead (refer to
the section 2.3.3.2 of this manual.)
UGA control through a remote PC
Please note!
You must install the software with
administrator account privileges.
This is critical for Vista, Windows7 or higher. This program needs the
full privilege of writing data.
