SRS Labs Nitrogen Laser NL100, Руководство по эксплуатации и обслуживанию

Страница: 13 / 25

Operation 3
NL100 Nitrogen Laser
internal trigger (see RATE below) or from an external trigger. The key cannot be
removed from the key switch when the switch is in the ON position.
Power Input
The NL100 requires 24V DC, 3A peak, 1.5 A average input power. Power may be
applied through a Hypertronics #D01PB 306 MST plug connected to the Hypertronics
receptacle located on the bottom right of the back panel. A Hypertronics connector is
supplied with your laser. Alternatively, power can be supplied through the DB-9
connector (see DB-9 CONNECTOR below).
Figure 8. Hypertronics power receptacle, as viewed from the back panel of the NL100. Supply
+24V DC on Pin 1. Pin 2 is the supply return and pin 3 is the case ground.
Sync Out (Optional)
This BNC connector outputs a +5V pulse into 50 Ohms synchronously with the laser
emission from the front aperture. Figure 9 shows a single shot from the sync out BNC
captured with an oscilloscope.
Figure 9. Single shot oscilloscope trace of the sync out of the NL100.