SRP UAB SERIES, Инструкция по установке, эксплуатации и обслуживанию

Страница: 17 / 36

Series UAB Page 17 Feb 18/2015
INSTALLATION SEQUENCE

Install Reflector Support Brackets (refer to Figure 12 and Figure 13), one at each reflector overlap
position, and one in the middle of each 10-foot reflector length.
Figure 12 : Reflector Bracket Installation

Secure every second reflector overlap together with #8 by 3/8 inch long screws, and secure
reflector to the reflector bracket at this point by tightening the screw supplied with the Reflector
Bracket as shown in Figure 11. The remaining reflector overlap joints and reflector brackets are
left loose to accommodate system movement (refer to Figure 3 for more details).
Figure 13 : Securing Reflector Overlap
1. Place Reflector Bracket
underneath the tube.
2. Hook the Spring Clip with
the Reflector Bracket and
over the tube.
3. Push down the Spring Clip
and slide underneath the
Reflector Bracket.
Spring Clip
Tube
Reflector Support Bracket
Secure every SECOND reflector
overlap with a minimum of 2
#8 x 3/8" long screws
on each side
Secure reflector to reflector
bracket by TIGHTENING
#8 x 1 1/4" long screws every
other overlap on each side.
LOOSE screws