Model SRV714 Series
Operating and Service Manual
Part No. MAN714_200601
Page 5 of 14
S
Instruments, Inc.
,
600 Young Street, Tonawanda, NY 14150
Tel: 716-693-5977 Fax: 716-693-5854 URL:
email:
Copyright 2020
S
Instruments, Inc.
ASSEMBLY (CON’T)
STEP 7:
Carefully place the center panel with electronics on an angle on top of one of the
previously assembled panels and one (1) transducer tube. When stable, plug in the two
(2) transducer cables that come from the display box under the center panel to each of
the transducer tubes. Ensure that the transducer cables are in line with the connectors
on the transducer tubes (Figure 4).
STEP 8:
After the transducers are plugged in, carefully align the center panel with the four (4)
alignment pins that are located in the center of the transducer tubes and slide it down
over the remaining transducer assembly pins (Figure 5).
NOTE:
Ensure all adjustable stainless steel feet are in contact with the floor, that the scale is
level and does not rock or twist.
NOTE:
If the scale is going to be set up in the same location repeatedly, it may be helpful to
outline the feet of the scale after the scale is fully assembled to assist with placement of the
transducer tubes in the future.
Display Box
Connector
Transducer Tube
Connector
(Under Alignment
Pin)
Figure 4: Center Panel Assembly
Figure 5: Final Assembly