Model SRV714 Series
Operating and Service Manual
Part No. MAN714_200601
Page 4 of 14
S
Instruments, Inc.
,
600 Young Street, Tonawanda, NY 14150
Tel: 716-693-5977 Fax: 716-693-5854 URL:
email:
Copyright 2020
S
Instruments, Inc.
ASSEMBLY
ASSEMBLY STEPS
STEP 1:
Unpack Large Animal Platform Scale (1) and check parts against PACKING CHECKLIST.
If there are any missing or damaged parts, call Service Hotline at: 1-800-654-6360.
STEP 2:
Remove the center panel to access the Display Housing (see Figure 4). Unplug the two (2)
transducer cables that come from the display box. Unscrew the four (4) screws from the
plastic cover on the display housing. Loosen the two thumb screws on the battery holder
cover and remove the cover. Install the six (6) “D” cell batteries according to battery holder
imprinted instructions. Attach the battery holder cover and tighten the thumb screws. Re-
secure the plastic cover with the four (4) screws.
STEP 3:
Remove the other two end panels from the Transducers.
STEP 4:
Place one (1) load cell spacer (metal ring) over the threaded stud of each of the six (6) load
cells. Then thread on one (1) rubber foot on each of the threaded studs (Figure 1).
STEP 5:
Place the two (2) Transducers, with the adjustable stainless feet resting on the floor, parallel
to each other and approximately four (4) feet apart (Figure 2).
STEP 6:
Align one of the end panels (without electronics) with the alignment pins at either end
of the transducer tubes. Carefully slide the panel down onto the alignment pins in the
transducer tubes. Ensure that the panel is sitting flat on the tubes and all four (4)
alignment pins are engaged. Repeat this step for the opposite end (Figure 3).
Figure 3: End Panel Assembly
Figure 2: Transducer Setup
Figure 1: Foot Assembly
FOOT
STUD
SPACER