Model SR2555 Stand-On Scale
Rev 991222
1.4
ASSEMBLY
IMPORTANT:
All of the scale systems
are calibrated at our factory as a
complete system. Components should
not be interchanged with other
systems. To assure optimal accuracy
and reliability, make sure the serial
numbers on the readout (2) and the
base (1) match.
1.
Insert mast(5) into base assembly
(1) as shown.
2.
Remove the 4 set screws (10) from
the base collar and apply loctite
®
to all set screws
3.
Make sure the mast is seated firmly
in the base assembly. Re-install the
set screws and tighten.
4.
Slide the cable from the display
assembly (2) down the mast (5)
and out through the base.
5.
Insert the mast (5) into the collar of
the display assembly (2) and seat
firmly. Turn the readout assembly
(2) so that it is aligned with the
base assembly.
6.
Apply loctite
®
to all set screws and
tighten display assembly in place.
7.
Plug the display assembly cable
into the base assembly as shown
and secure the cable in place with
the strain relief clamp provided at
the bottom of the collar in the
base assembly. Make sure the
excess cable is fed back into the
mast (5) before tightening the
strain relief clamp.
8.
Remove the battery cover (8) and
install the 6 “LR14” (C cell) batteries
provided. Replace the cover.
OPTIONAL HANDRAILS –
Install the handrails with the hardware
provided. Be sure to use the lock
washers (12) and apply loctite
®
to all
screws.
1.
Attach the LEFT and RIGHT handrails (3,4) to the bottom of the readout assembly (2) first and then to the base (1)
as shown.
OPTIONAL HEIGHT BAR –
1.
Insert the Height Bar (6) from the top making sure it is seated firmly at the base.
2.
Align the top extension perpendicular to the readout
3.
Apply loctite
®
to all set screws and tighten in place
Page 3