5
Copyright 2013 DTX International
G. Install the inner diffuser lens (I) into the light box using
the hook & loop fasteners on the inside the softbox body
(Figure 6).
H. The final step in completing
the softboxes is to install the main
diffuser lenses (H) over the softbox
body by hooking one corner of the
lens over one corner of the body and
fitting the entire lens over the soft
box, then securing it on all four sides
with the attached hook & loop
fasteners (Figure 7).
4. The light stand tripods (F) are
pre-assembled, and only require
that you fold the legs outward by
loosening the locking wingnut
and sliding the legs outward so
that the tripod will stand on it’s own.
5. Loosen the locking nut that secures the legs on the light
stand and slide the base ring downwards to spread the
legs outward. This will allow the light stand to stand
upright.
6. The light stands can be raised or lowered by loosening
the wingnuts at several levels on the shafts in order to
set your lights at the desired height (Figure 8).
7. Remove the little black cap from the end of
the light stands as seen in the top of Figure 8.
8. Loosen the wingnut on the light body enough
to allow the top post of the light stand to slide
through.
9. Place the light fixture/softbox assembly on top
of the light stand and tighten the wingnut
(Figure 9).
10. Install the power cord (C) into the back of
the light body.
11. Your light stand is now complete. Repeat
the process for the second light stand. Happy
shooting!
Figure 7
Figure 8
Figure 9
