16
17
English
English
SETTINGS
To define the options of the camera. To set the system in
English, hold the button
until "Language" is highlighted.
Press OK, select "English" and confirm your choice with
OK. The system will than change all the menus to English.
Time Start /
Time Stop:
Allow the user to set the period of
operation of the camera. The start and stop
time are the hours during the camera is
in action and records pictures or videos.
Example: if the user selects a start time
"7:00 am" and a stop time "11:00 am",
the camera will only detect for that period
of time and will stay inactive for the
remaining hours. Press OK and use
or
to adjust the hour. Press again OK to set
the minutes. When the time is properly set,
press OK once more to go back.
For an activation of 24 hours, the same
start and stop time must be entered
(example: 00:00 as start time and 00:00
as stop time.
These hours are the basic
settings of your camera)
Note:
The hours can be recorded over a
12 or 24 hours period. Refer to "Setting"/
"Time format" (00:00 means midnight).
Delay:
(10s/1m/3m/5m/
10m/15m/30m)
Select the time interval between photos or
videos.
Additional setting
: It is possible to
decrease the delay between detections to
10 seconds (instead of 1 minute) by using
the following procedure.
Note that the
battery life will be affected.
Turn OFF the camera. Press and hold the
button and turn the camera ON . "10sec
enabled" appears on the screen meaning
the minimum delay is now 10 seconds.
If this option is used, the 30 minute delay
disappears. To reset the camera to 1
minute delay, follow the same procedure.
"10sec disabled" appears on the screen
(see figure below)
Multi-shot:
(1/2/3/4/5/6
consecutive
shots)
Take up to 6 consecutive shots at each
detection, with a 10 second delay between
each photo. This option allows up to 6
pictures from different angles when the
camera is in PHOTO mode.
10SEC DISABLED
10SEC ENABLED
10 sec delay
1 min delay
