A.0200.301 – IM-TA/03.00 EN (03/2007)
29
O ring
Center disk
Diaphragm
Center disk
Nut
Coned disk spring
Center Rod
Cushion
O ring
Fig 7.9
• Apply lubricating oil to the center rod, and
insert it into the main body.
• Keep the marking “LIQUID” to liquid end for
CR, EPDM, NBR diaphragms.
• Keep the convex side to the outside for PTFE
diaphragm.
• Install the O ring (cf. Fig. 7.9).
•
TA-5 FPT, FVT
– Tighten the center disk using
the accessory tool (special tool: Part No.
271-771132).
•
TA-15 FP_, FVT
– Tighten the center disk
using the open-end wrenches.
(No coned disk springs and nuts are needed).
• After installation of the “out” chambers on
both sides, place the pump on a flat surface
and stand the pump upright for further
assembly.
Tightening torque for center rod and out
chamber
TA-5
7.5 Nm
TA-15
12 Nm
Note
• Make sure there is no dust on the seal surface
in order to prevent seal damage.
• Replace the PTFE O ring by new one.
• Tighten the bolts so that the balance is equal
from both sides on diagonal line with even
torque.
17.3.2 B_C, B_E, B_N, B_T, FPC, FPN, F_E, F_T - types – See 20.0 Exploded View
Assemble in the reverse order of disassembly.
Содержание JOHNSON PUMP TopAir TA-15
