5
Before Initial Use:
Before using the ice maker for the first time or after a long idle period, it is strongly recommended to clean it
thoroughly:
1. Be sure unit is powered off and unplugged. Clean the water reservoir with diluted mild detergent and
warm water solution.
2. Drain the water by removing the drain plug.
3. Rinse thoroughly with clean water and drain.
4. Replace the drain plug and add clean water.
5. After connecting power supply, press and hold SELECT button for 3 seconds to activate pipeline
self-clean process. Drain water when the process is done.
6. Open the lid and take out the ice basket, wash with mild detergent under running water.
Operating Instructions
：
：
：
：
1. Open the lid and take out the ice basket.
2. Add water up to the MAX line – do not overfill.
3. Replace the ice basket and close the transparent lid.
4. Connect power and press POWER button.
5. Select desired ice size
Note: Water added into the reservoir should be lower than the MAX water line. When water volume
goes beyond the max line, please unplug the water drain to remove excess water.
Note: Please select size (S) when ambient temperature is below 59°F. When ambient temperature is
higher than 86°F, Large ice cube size is recommende d.
Note: For the first three cycles, the ice may be small and irregular in size.
Note: When the ice basket is full please remove the ice immediately. Do not allow the ice basket to
overfill.
Warning: Keep unit away from direct sunlight.
Warning: Change water in the reservoir every 24 hours to ensure a reasonable hygiene level. If unit is
not to be used for a couple days, drain all the water and dry the tank.
