6
Cleaning & Use Guidance
：
：
：
：
1. Clean the inner liner, ice basket, water reservoir, ice shovel and evaporator frequently. When cleaning,
unplug the unit and remove the ice cubes. Use a diluted solution of water and vinegar to clean the inside
and the outside surface. Do not spray with chemicals or diluted agents such as acids, gasoline or oil.
Rinse thoroughly before restarting.
2. Keep ventilation openings in the appliance enclosure, clear of obstruction.
3. If unit has been sitting idle for a period of time, the ADD WATER indicator may be flashing, this is due to air
bubbles trapped in the piping. If this occurs, press the POWER button and unit will return to normal state.
4. To ensure the cleanness of ice, please change water for water reservoir at least once a day. If unit is not to
be used for a long time, please drain the water out and clean.
5. If the operation is interrupted due to water shortage or interruption of power supply, there will be a
3-minute delay before unit will restart. This is to protect the compressor.
6. Always use fresh water for ice production either at initial installation or after a long shut-off period.
Troubleshooting
：
：
：
：
1. Please note, if a power failure occurs due to disconnection of the power cord, or the power button has been
pushed off during an ice making cycle, small ice chips may form and get lodged in the ice shovel causing it
to jam. If this occurs, turn unit off and disconnect power. Gently push the shovel to the rear and remove the
ice chip. Restart unit.
2. Ice chip lodged in the ice shovel can also cause the water tray to be uneven or ice shovel unable to push ice
cubes into the basket. If this is the case, turn unit off and disconnect power. Check for ice chips and
remove. Restart unit.
PROBLEM
POSSIBLE CAUSE
SUGGESTED SOLUTIONS
The compressor works
abnormally with a buzzing
noise
The voltage is lower than
recommended
Stop the ice maker and do not restart until
the voltage is normal.
Water shortage indicator is on
1.There is no water
2.The pump is full of air
1.Add water up to the MAX line.
2.Press POWER button to restart
Indicator lights are not on
Blown fuse/ No power
Replace fuse / Turn power on
The ice made is too large and
with pieces sticking together.
1.water temperature is too
low
2.Ice of previous cycles left
in the water tray
1.Select small size
2.Take out the ice under the standby state
All indicators twinkle
simultaneously
Water tray is blocked by ice
cube
Unplug power. Take out the ice that is
blocking the tray, then plug the power and
press the POWER button, the machine
will restart after 3 minutes.
