SPRT
２２
FS S n1 n2 Set Chinese Character Left and Right Spacing
Format: ASCII
：
FS S n1
n2
Decimal: 28 83
n1
n2
Hexadecimal: 1C 53
n1
n2
Explanation:
Set Chinese character left spacing. n1=0
～
32, default n1=0
Set Chinese character right spacing. n2=0
～
32, default n2=0
When using ESC! <0> to select character A (5
×
7 whole dot character) ,
utilize ESC SP <4> command to make the dot width of a Chinese character
equal the one of a whole dot ASCII character.
When using ESC! <1> to select character B (7
×
7 half dot character) ,
utilize FS S <0><4> command to make the dot width of a Chinese
character equal the one of two half dots ASCII character.
3.2.5 Black Mark Control Commands
GS
（
F pL pH a m nL nH Set the Offset of Black Mark Localization
Format: ASCII
：
GS
（
F
pL pH a
m nL nH
Decimal: 29 40 70 pL pH a m nL nH
Hexadecimal:1D 28 46 pL pH a m nL nH
Explanation:
This command is used to choose black mark localization control
permission, and set the offset of cutting/tearing paper position or initial
print position relative to black mark test position. This value is calculated
in dots number mode.
The relevant parameters of this command are:
pL
＋（
pH
×
256
）
4 namely pL=4
，
pH=0
1
≤
a
≤
2
m=0, 48
0
≤
(nL+nH
×
256)
≤
1700
·
a is used to set the offset of cutting/tearing paper position or initial print
position.
A
Function
1
Set the offset of initial print position relative to
black mark test position
2
Set the offset of cutting/tearing paper position relative to
black mark test position
