+ 6 4 0 9 6 3 6 - 7 0 7 0 | W W W . S P R I N G N Z . C O . N Z | S A L E S @ S P R I N G N Z . C O . N Z
C
o2 BOTTLE - INSTALLATION
1.
Ensure the Co2 bottle is connected firmly to the regulator and the Co2 tube is
fitted
correctly.
2.
Slowly turn the dial on the regulator clockwise until the gauge reads 3BAR
(Note: If you want to reduce the pressure you must first turn the dial anticlockwise
and then vent
to relieve existing pressure
. The gauge will then settle and read
accurately)
3.
Turn off the water at the valve and purge any air from the sparkling line b
y
pressing the
sparkling button on the tap for 30 seconds.
4.
Turn the water back on at the valve and the SODA switch at the rear of the unit.
5.
Press the sparkling button on the tap for 15 seconds to allow any excess Co2 to
be dispensed
6.
Operate the sparkling button on the tap 2-3 times for 15seconds each time
(1minute
cooldown) until you notice the water is sparkling. Pressure will
fluctuate
between 3-4 bar
All Co2 bottles should be upright during use, storage and transit. If the bottle has
been left horizontal, place upright and stand for 60+ minutes before use to allow
contents to settle
Co2 Refill Tube
Pressure Gauge
Pressure
Regulator
1/4" Pipe
Co2 Bottle
TOP VIEW - Co2 Bottle
