SpraMigo TCB100, Руководство пользователя

Страница: 16 / 23

FOR BLOWER MODELS: Echo PB 413T, 500H, 500T, 620H & 620ST
(REQUIRES 19.5” ALUMINUM FRAME SETTING)
IMPORTANT: USE LETTERS E MARKED ON NEW BASE FOR INSTALLATION TO BLOWER
FRAME ON ALL MODELS LISTED ABOVE.
Mounting New Base to Blower Frame
1. Remove blower body from blower frame (remove gas from tank first)
2. Turn blower frame upside down the back closest to you. See illustration A-5.
3. Place blower frame on top of base. Align back of blower flush with back and right side of base. See
illustration A-5. Using C-clamps or some other method, secure frame to base. Turn frame and base upside
down while keeping proper alignment. See illustration A-5.
4. Drill (4) 1/4” holes using E marks as guides. Unclamp frame and base.
5. Install (4) tee nuts in 1/4” holes on blower frame.
6. Installing Tee Nuts:
See illustration Tee Nut Installation
A. Place tee nut in 1/4” hole and press until the three prongs contact the frame.
B. With a pen, mark the spots where the three prongs touch the frame.
C. Remove tee nut. Using a 5/64” bit, drill a hole centered within the three pen marks.
D. Press tee nut into place and repeat with remaining tee nuts.
7. Securing New Base to Blower Frame:
Use holes marked E . To avoid frame damage, DO NOT OVER TIGHTEN SCREWS .
Hardware needed:
(4) #10-32x2” Screws
(4) #10-32 Flat Washers
(4) #10-32 Lock Washers
(4) #10-32x 5/16” Tee Nuts
8. Reattach blower body to blower frame.
9. Assembling Aluminum Frame:
A. Slide L-shaped piece into aluminum frame piece.
B. Snap pin into correct position for your blower model and tighten screw cap by hand. Repeat
for other side.
10. Mounting Aluminum Frame to New Base
A. Place aluminum frame legs in two slots of new base with ends of legs toward front of blower
frame.
B. Locate letters
FM
marked on each side of the base.
C. Install #10-32x1 1/4” screws to support aluminum frame.
Hardware Needed:
(4) #10-32x1 1/4” Screws
(4) #10-32 Flat Washers
(4) #10-32 Lock Washers
11. Mounting Spray Tank to Aluminum Frame
A. Unscrew caps on each side of installed frame.
B. Push adjustable snap pins in and remove top aluminum piece.
C. Pull on each side of frame to allow space for tank to snap into place.
D. Reconnect aluminum pieces.
14