SpraMigo TCB100, Руководство пользователя

Страница: 12 / 23

FOR BLOWER MODELS: Red Max EBZ 5100, 7001, 7100 & 7150
(REQUIRES 22” ALUMINUM FRAME SETTING)
Tanaka TBL 7800 & TBL 7800R (
REQUIRES 19.5” ALUMINUM FRAME SETTING)
IMPORTANT: USE LETTERS R MARKED ON NEW BASE FOR INSTALLATION TO BLOWER
FRAME ON ALL MODELS LISTED ABOVE.
Mounting New Base to Blower Frame
1. Remove gas tank from blower (remove gas from tank first).
2. Remove blower body away from blower frame.
3. Place blower frame on top of base. Align back of blower flush with back of base. Adjust base, leaving 1/4”
margin from each edge. See illustration A-3. Using C-clamps or some other method, secure frame to base.
Turn frame and base upside down while keeping proper alignment. See illustration A-3.
4. Drill (4) 1/4” holes using R marks as guides. Unclamp frame and base.
5. Install (4) tee nuts in 1/4” holes on blower frame.
6. Installing Tee Nuts:
See illustration Tee Nut Installation
A. Place tee nut in 1/4” hole and press until the three prongs contact the frame.
B. With a pen, mark the spots where the three prongs touch the frame.
C. Remove tee nut. Using a 5/64” bit, drill a hole centered within the three pen marks.
D. Press tee nut into place and repeat with remaining tee nuts.
7. Reinstall gas tank.
8. Securing New Base to Blower Frame:
Use holes marked R . To avoid frame damage, DO NOT OVER TIGHTEN SCREWS .
Hardware needed:
Front of Base Back of Base
(2) #10-32x1 1/2” Screws (2) #10-32x1 1/4” Screws
(2) #10-32 Flat Washers (2) #10-32 Flat Washers
(2) #10-32 Lock Washers (2) #10-32 Lock Washers
(2) #10-32x 5/16” Tee Nuts (2) #10-32x 5/16” Tee Nuts
9. Reattach blower body to frame.
10. Assembling Aluminum Frame:
A. Slide L-shaped piece into aluminum frame piece.
B. Snap pin into correct position for your blower model and tighten screw cap by hand. Repeat
for other side.
11. Mounting Aluminum Frame to New Base
A. Place aluminum frame legs in two slots of new base with ends of legs toward front of blower
frame.
B. Locate letters
FM
marked on each side of the base.
C. Install #10-32x1 1/4” screws to support aluminum frame.
Hardware Needed:
(4) #10-32x1 1/4” Screws
(4) #10-32 Flat Washers
(4) #10-32 Lock Washers
12. Mounting Spray Tank to Aluminum Frame
A. Unscrew caps on each side of installed frame.
B. Push adjustable snap pins in and remove top aluminum piece.
C. Pull on each side of frame to allow space for tank to snap into place.
D. Reconnect aluminum pieces.
10