Spotwave Wireless SpotCell 100, Руководство пользователя

Страница: 26 / 50

M
OUNTING
20
SpotCell 100, Release 1.0
4.2.3 Mounting the SCU
The SCU has a bracket attached as illustrated below. The
bracket can be rotated to allow mounting to a ceiling or wall
such that the face of the unit is parallel to the floor or ceiling, or
positioned at approximately 45 degrees.
Figure 4.5:Back of the SCU and the mounting bracket.
„
If mounting on a solid wood surface, or stud covered by drywall,
drill a 1/8th inch diameter hole and mount with screw ##(of which
there are 20).
„
If mounting in drywall, drill a ¼ inch diameter hole and insert
anchor ##(the nylon screw anchor of which there is one of ), and
then mount with screw ##(of which there are two, 2.5 inches long,
one being a spare).
4.2.4 Securing the Cable:
While securing the cable, ensure that a drip loop is fashioned near the
DDU (to prevent water from collecting around the cable where it
attaches to the DDU) and secured in place as shown in figure # below.
Figure 4.6:Drip loop
1.
Fashion the drip loop and fasten a tie wrap, item # (black tie wrap)
around the loop to keep the loop fashioned.
2.
Secure the cable to the wall using loop strap (item ##) as shown
below. Mount the loop strap directly to the wall where possible
using screw ##(1 of the 20 screws).
If an anchor is required, drill a 3/16 hole, and then mount using
screw ##(1 of the 20 screws). Use white screw anchors outdoors, and
plastic screw anchors indoors (of which 10 are supplied) if anchors
are required.
4.2.3 Grounding:
Ensure there is a connection to earth ground. Use an appropriate
conductor connected from the stud on the DDU to earth ground
Figure 4.7:Grounding the DDU