broadcasting signal is cut off for more than two seconds, the Scan will
resume until another signal is found.
The Scan may be canceled at any time by pressing the Clear Key. The
direction of the Scan may also be reversed at any time by pressing and
holding the Up or Down Key (whichever is appropriate) for one second.
Once you have pressed the Clear Key to exit a Scan, you are still in
the Recall function. Press the Clear Key again to exit the Recall
function. The SP-200 will remain on the last frequency received.
It is very important that the Squelch be properly adjusted prior to
initiating a Scan. The background static received with the squelch off
may be strong enough to disrupt a Scan. If a Scan gets “stuck” on a
frequency with too much background noise, increase the Squelch or
press and hold the Up or Down Key for one second to skip that
frequency and resume Scanning. Please note, since ATIS broadcasts
continually, a Scan will always stop on an ATIS frequency if it is
included in the Scan.
Memory Clear
To clear or erase a memory channel, press and hold the Clear Key
followed by the Memory Key. Release the keys when MEM CLR is
displayed on the top line of the screen.
The first memory channel with a stored frequency will be displayed
on the bottom line of the screen. Press the Up or Down Key to scroll
through the memory channels to select the memory channel to clear.
Once the desired memory channel is displayed, press the Memory
Clear Key (also the 0 Key on the Numeric Keypad) to clear the
selected channel. Additional channels may be cleared by once again
pressing the Up or Down Key to make another selection and then
pressing the Memory Clear Key.
17
122.975
01
MEM CLR
SP-200 BOOKLET 9/28/04 5:46 PM Page 21
