June 12, 2020
1
902-293 6’ INDEPENDENT SECTIONAL STRAIGHT (VL) SLIDE
EQUIPMENT MAINTENANCE
Plastic Components
Inspect for any sharp edges or
deformities. Minor deformities
and sharp edges can be repaired
using a utility knife. Block off
access until repairs are made.
Contact distributor for
replacement parts.
Brackets
Inspect all four-hole clamps and
panel clamps.
Ensure the setscrews are tight and
in place.
Ensure all Torx Screws are in
place and that the bracket is
firmly attached to post.
Inspect the clamps for cracks and
sharp edges. Smooth any sharp
edges and fix the finish. Replace
brackets if cracked.
Hardware
Inspect for loose or missing
hardware. Tighten all loose
hardware and replace all missing
hardware. Block off access to
equipment if necessary.
Welds
Inspect all welds for cracks. If a crack is found
block access to the playground and contact your
distributor for replacement parts immediately.
Finish
Inspect all metal components for coating damage. If
powder coating needs to be repaired sand surface
and mask off area. Coat with primer and once the
primer has dried paint with color matching touch up
paint. Contact distributor of color matching paint.
Contact Distributor for Thermoplastic repair kit.
Slide
Refer to “Plastic Components”
section.
Inspect run-out section of the slide for
standing water. Adjust the slide by
digging up existing footing and install
it slightly lower to increase the slope
of the slide.
Replacement Parts
Reference the parts list on page 2 of
the instruction set for this component
to identify the part/s correctly.
Contact your distributor to order parts.
Footings
Inspect all footings to ensure
equipment is secure. You must block
access to prevent access until repair is
made.
Surfacing -
Refer to the surfacing maintenance sheet.
