DROP ATTACK
TM
RUGBY MACHINE
Sports Attack, LLC.
•
800-717-4251
•
www.sportsattack.com
5
SHUTTING DOWN & TRANSPORTING
TURNING Drop ATTACK “OFF”
1. Set each speed control dial to “0”.
2. Turn the power switch “OFF”.
3. Unplug Drop Attack from the power source.
TRANSPORTING
1. Be sure machine is turned “OFF” and wheels are not turning.
2. Unplug cord from extension cord, standard outlet or generator.
3. Transport lock pin must be inserted in hole to right, locking head into position for
transporting (See Figure A).
4. Using the elevation control, tilt the throwing head up (to high position) and lock
into place (See Figure B). This will facilitate transporting.
5. Using handles (See Figure C) tip machine up and over onto the wheel guards.
Unsocket two lower (front) legs, leaving upper (rear) leg in socketed position.
6. Lift rear leg and roll machine (See Figure D).
Shutting Do
wn & T
ranspor
ting
Figure D
Lift rear leg and roll. Shown being
used with pass and punting stand.
Figure C
Use handles to lift or lower the
Drop Attack.
Figure A
Lock pin inserted to lock throwing
head into position for transporting.
Figure B
Loosen stand elevation handle.
WARNING
PERSONAL INJURY
HAZARD
Never reach down near throwing
wheels for any reason! Always
turn all three speed control dials
“0”, turn the power switch “OFF”,
unplug Drop Attack from the
power source and wait until the
throwing wheels have come to
a complete stop before reaching
hands or fingers anywhere near
throwing wheels.
Lock Pin
Horizontal
Control
Elevation
Handle