DROP ATTACK
TM
RUGBY MACHINE
Sports Attack, LLC.
•
800-717-4251
•
www.sportsattack.com
2
Safety Instructions
SAFETY INSTRUCTIONS
ELECTRICAL SAFETY
Use a 110 or 220 volt (to match the power source) single phase 3-wire grounded
power source.
Up to 200 ft. from power source, use a minimum #14/3 grounded 3-wire extension cord.
Over 200 ft. from power source, consult a licensed electrician for required power cord size.
OPERATING SAFETY
CAUTION:
Never reach down near moving throwing wheels for any reason! If it is
necessary to reach into the throwing wheels,
ALWAYS:
1. Turn speed dial to “0”.
2. Turn the power switch “OFF”.
3. Unplug Drop Attack from power source.
4. Wait until the throwing wheels have come to a complete stop before reaching hands
or fingers anywhere near the throwing wheels.
CAUTION:
Carefully check Drop Attack for completeness and condition before
connecting to electrical power.
Carefully check the throwing wheels frequently for cleanliness, chips and cracks. Do not
use the machine if the throwing wheels are damaged, or if chips or cracks appear in the
wheels. (For damage within warranty period, see Warranty Statement, page xi.)
ALWAYS
set the speed control to “0” before connecting the machine to power.
Check that the speed control is at “0” before turning the throwing wheels “ON”.
Do not allow anyone to walk in front of the Drop Attack Rugby Machine if it is
connected to electrical power.
CAUTION: DO NOT
plug in or energize this equipment until all assembly instructions and
operation instructions are read and followed.
BALL SELECTION
Balls must be official size and consistent in type to produce repeatability.
Never use wet or damp balls! Ball air pressure must be between 9.5-10.0 lbs.
WARNING
PERSONAL INJURY
HAZARD
Carefully read all instructions in
this manual, and all labels and
warnings on Drop Attack
before using this machine.
Use machine only under adult
supervision. Failure to operate
Drop Attack as described in
this manual can result in severe
personal injury or death.
ELECTRICAL SHOCK
HAZARD
The Drop Attack must be
connected to a properly
grounded electrical receptacle.
•
Do not operate on wet ground.
CAUTION
PERSONAL INJURY
HAZARD
Keep hands away from throwing
wheels anytime the machine is
connected to a power source.
•
Carefully check the Drop
Attack for completeness and
condition before connecting
to electrical power.
EQUIPMENT
ELECTRICAL DAMAGE
Keep hands away from throwing
wheels anytime the machine is
connected to a power source.