DROP ATTACK
TM
RUGBY MACHINE
Sports Attack, LLC.
•
800-717-4251
•
www.sportsattack.com
4
Setting-up As A P
assing Machine
SET-UP & PREPARATION
USING THE DROP ATTACK
IMPORTANT:
Lock pin must be removed (See Figure 5) and stored in adjacent hole to left.
This will allow machine to pivot horizontally.
IMPORTANT:
For maximum distance, balls must be properly inflated.
A. Setting machine up
1. Tilt machine up onto wheel guards.
2. Using wing nuts which are stored on bolts, attach throwing head to undercarriage,
tighten wing nuts securely to passing stand (See Figure 6).
3. Insert 3 legs into sockets.
4. Using lifting handles tilt machine up onto all three
tripod legs.
5. Remove lock pin and store in adjacent hole to left (See Figure 5).
6. Loosen horizontal control handle (See Figure 5).
7. Loosen stand elevation handle (See Figure 7).
8. Plug machine into power source. (110v or 220v)
9. Turn power switch “ON.”
10. Dial wheel speed to approximate speeds.
11. Continue throwing test balls and adjusting speeds until desired distance and speed
is achieved.
12. To tilt throwing wheel to throw either end over and drop kick or spiral passes
loosen wheel tilt lever and pivot motor.
Figure 5
Lock pin inserted to lock throwing
head into position for transporting.
Lock Pin
Horizontal
Control
Figure 7
Loosen stand elevation handle.
Figure 6
Attaching throwing head to
undercarriage.
Figure 2
Remove wing nuts.
SAFETY HINT
When lowering or lifting, Drop
Attack keep your back straight
and lift with your legs. Be ready
to grab the wheel guard and
guide Drop Attack into the
upright position.
WARNING
HAZARD FROM
HIGH-SPEED
PROJECTILES
Being struck by a thrown ball can
cause serious injury or death.
Make sure that no one steps in
front of Drop Attack while it is
connected to electric power.
Clear everyone away from
machine before connecting
Drop Attack to electric power.
Figure 1
Use handles to lift or lower
the Drop Attack.
Wing
Nuts
Wheel Tilt Lever
Elevation
Handle