SportDOG Upland Hunter 1875, Руководство по эксплуатации

Страница: 21 / 32

WWW.SPORTDOG.COM 21
CHANGE ID CODES
An ID Code is the signal identifi cation between the Remote Transmitter and Collar Receiver. Each
is programmed in 1 of 2,000 ID Codes from the factory. The UplandHunter
® 1875 has the fl exibility to
program two or more Remote Transmitter’s to the same ID Code allowing them to control one Collar
Receiver. There are 64 programmable ID Codes available.
TO MANUALLY PROGRAM A REMOTE TRANSMITTER’S ID CODE FOLLOW THESE STEPS:
1. Turn the intensity dial to V/T, fl ip the toggle switch up, and then press and release the mode
button on the back of your Remote Transmitter. This does not change the mode, so the current mode
will still be active after the ID change is complete.
2. Once the mode button is released, the green indicator light will illuminate and stay on for
15
seconds.
3. While the green light is on, turn the intensity dial to select the 1st digit of the ID and then press and
release the left-side button. The green light will fl ash rapidly confi rming selection.
4. Again, while the green light is on, turn the intensity dial to select the 2nd digit of the ID and then
press and release the left-side button. The green light will fl ash rapidly confi rming selection. The 2nd
digit is optional, and if not desired, just wait until the green light turns off and refrain from pressing
the side button.
5. At the end of 15 seconds, or after the second press of the left-side button, the green light will turn off
and the ID of the unit will be updated. At this point, the unit will be in the same mode it was in prior
to setting the ID.
6. Upon changing the ID Code, you will need to match the Collar Receiver and Remote Beeper to the
Remote Transmitter (see Step 7 on page 18).
NOTE: If you press the left-side button only once (skipping Step 4) the ID is still a two digit ID. The left
digit is defaulted to 1. For example, if you selected 6 in Step 3 and pressed the button only once, the
ID you get will be 16.
TO RETURN THE UNIT TO THE FACTORY ID FOLLOW THESE STEPS:
1. Turn the intensity dial to V/T, fl ip the toggle switch up, and then press and release the mode
button on the back of your Remote Transmitter. This does not change the mode, so the current mode
will still be active after the ID change is complete.
2. Do not press any buttons and wait until the green indicator light turns off.
3. You will now need to match the Collar Receiver and Remote Beeper to the Remote Transmitter (see
Step 7 on page 18).
ST
E
P
::
11