SportDOG Upland Hunter 1875, Руководство по эксплуатации

Страница: 19 / 32

WWW.SPORTDOG.COM 19
5. You do have the ability to select a different tone for each dog. For Dog 2, follow the previous steps
using the Lower Button in place of the Upper Button. For Dog 3, follow the previous steps using the
Locate Button in place of the Upper Button.
6. Turn the Intensity Dial one position. The Remote Transmitter’s Indicator Light will turn off.
7. Press the corresponding button for each dog (with the toggle switch in the
up position) and the
selected tone will play.
CHANGE RUN MODE
The Run Mode is changed using the Run Mode button on the Remote Transmitter. You have three
choices of how often the beeper sounds off when your dog is moving: Never (Silent Mode), every 5
seconds (5 Second Mode) or every 10 seconds (10 Second Mode). In all modes, the Remote Beeper
beeps once per second when the dog stops moving.
1. Press and hold the Run Mode button while viewing the back of the Remote Transmitter.
2. After 2 to 3 seconds, an indicator light next to the current run mode will light up.
3. Continue holding the Run Mode button until the indicator light for the desired mode lights up.
4. Release the Run Mode button. The Indicator Light next to the corresponding mode will fl ash several
times indicating the new run mode is set.
NOTE: If you would like different run modes for each dog in 3-Dog operation, follow the instructions
below to manually confi gure each of their Remote Beepers.
LOCATING YOUR DOG IN THE FIELD
Anytime your dog is within one mile, you can make the Remote Beeper beep by pressing the Locate
Button on the Remote Transmitter. The Remote Beeper will beep once each time you press the button.
Pressing the Locate Button disables the Remote Beeper’s run mode, but it is still on. To reactivate the
run mode, press and release the Remote Transmitter’s Run Mode button. The Remote Beeper will emit
3 beeps to confi rm run mode has been activated and will continue operating in the last run mode in
which it was set.
MANUALLY CONFIGURE REMOTE BEEPER
While the Remote Beeper can be remotely programmed from the Remote Transmitter, you can also set
tone and run mode from the beeper itself.
1. Turn the Remote Beeper off.
2. Press and release the On/Off button to turn on the Remote Beeper.
3. Within 5 seconds press and hold the On/Off button. The Remote Beeper will begin to cycle through
available
tones.
4. When the desired tone is heard, release the button before the next tone starts. Tone is now set.
5. Press and hold the button immediately following tone selection completion until the number of
beeps matches the desired run mode as shown in the chart below.
1 Beep (Silent)
No beep when dog is running/Beeps once per second when
dog is on point
2 Beeps (5 second) Beeps every 5 seconds when dog is running/Beeps once per
second when dog is on point
3 Beeps (10 second) Beeps every 10 seconds when dog is running/Beeps once per
second when dog is on point
6. Release the button after the corresponding number of beeps matches your desired run mode.