14
1-800-732-0144
WWW.SPORTDOG.COM
15
fCC CompLIanCe
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a specific installation. If interference does occur to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
• Contact customer service or an experienced radio/TV technician for assistance.
Caution: Unauthorized changes or modifications to the equipment may violate FCC regulations and
could void the user’s authority to operate the equipment.
IC - CanaDa
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit
pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
Customer Care Center / Service clientèle
800-732-2677
Monday - Friday / Lundi - Vendredi
8 am - 8 pm / 8h00 - 20h00
Saturday / Samedi
9 am - 5 pm / 9h00 - 17h00
Battery DISpoSaL
See important safety information on page 2 related to the battery.
This system operates on one Li-Ion battery pack (400mAh for the Remote Beeper). Only replace with
battery received from calling the Customer Care Center at 1-800-732-0144.
Separate collection of spent batteries is required in many regions; check the regulations in your area
before discarding spent batteries. Please see below for instructions on how to remove the battery
from the product for separate disposal. If you wish to ship us your spent batteries for disposal, contact
the Customer Care Center.
AT END OF PRODUCT LIFE, USE THESE BATTERY REMOVAL INSTRUCTIONS FOR FINAL DISPOSAL
(DO NOT OPEN THE REMOTE BEEPER UNTIL YOU HAVE RECEIVED THE REPLACEMENT):
• Using a #1 Phillips screwdriver for your Remote Beeper remove the case screws.
• Remove the case back or cover.
• Remove the old battery pack.
Note: When removing the old battery pack, care must be taken when
gripping the connector firmly to avoid damaging the wires. Shorting the battery wires may cause
fire or explosion.
Note: these instructions are not valid for repair or battery replacement. Replacing the battery with a
battery not specifically approved by Radio Systems
®
Corporation may cause fire or explosion. Please
call the Customer Care Center at 1-800-732-0144 to avoid invalidating your warranty.
This product is protected by the following patents:
For use under U.S. Patent No. 7,814,865
