6
1-800-732-0144
Prepare the Collar Receiver
Charge the Collar Receiver
1. Lift the rubber cover protecting
the Collar Receiver Charging Jack.
2. Connect the charger connector to
the Collar Receiver Charging Jack.
3. Plug the charger into a standard
120-volt AC wall outlet.
4. Charge the Collar Receiver for
24 hours for the fi rst charge.
Recharges take only 12 hours.
Note: The Receiver Indicator Light
will fl ash after 12 hours of charging.
For the fi rst charge, continue to
charge the Collar Receiver for an
additional 12 hours.
5. When charging is completed,
replace the rubber cover.
Charger connector placed
in Collar Receiver Charging Jack
If the Collar Receiver is used in or around salt water, the Collar Receiver should be
rinsed with fresh water following each use. Prior to rinsing, the power cover should be
removed from the power plug socket and left out until the Collar Receiver has air dried.
To Turn the Collar Receiver On:
1. Press and hold the On/Off Button until
the Receiver Indicator Light comes on
and the Collar Receiver beeps 5 times.
2. Release the On/Off Button.
The Receiver Indicator Light will fl ash
until the Collar Receiver is turned off. The
fl ashing light indicates the Collar Receiver
is ready to receive a radio signal from the
Remote Transmitter.
On/Off Button
To Turn the Collar Receiver Off:
1. Press and hold the On/Off Button until the Receiver Indicator Light comes on and
the Collar Receiver beeps 2 times.
2. Release the On/Off Button.
To extend the life between charging cycles, turn the Collar Receiver off when it is
not in use. Approximate battery life between charges is 40 to 80 hours, depending on
frequency of use.
Step
2
