10 |
EN | instruction
4. ASSEMBLY INSTRUCTIONS
5. METER MANUAL
STEP 1- (B):
1. Remove the paper tube, carriage bolt (30),
arc washer (31) and cap nut (32) from the front
bottom tube (33).
2. Tighten the front bottom tube (33) to the ma-
inframe (1) with carriage bolt (30), arc washer
(31), and cap nut (32).
STEP 2 - (C):
1. Remove the cushion (24), screw (45) and fixed
plate (44), then install the slide saddle (18) onto
the slide rail (22), and tighten the cushion (24) to
the slide rail (22).
2.Tighten the fixed plate (44) to the slide rail (22)
with screw (45).
STEP 3 - (D):
Dokręcić tylną podporę (29) do szyny ślizgowej
(22) za pomocą śruby sześciokątnej (25), płaskiej
podkładki (8) i nakrętki nylonowej (9), a na-
stępnie dokręcić osłonę ochronną (28) do tylnej
podpory (29) za pomocą pokrętła (2) i śruby (27).
STEP 4 - (E):
1. Connect the connection wire (46) to the sensor
wire (36), then tighten the slide rail (22) to the
mainframe (1) with hexagon bolt (14), knob (2),
knob (15), flat washer (35), flat washer (8) and
nylon nut (9), cover the cap (70) at last.
2. Tighten the pedal (11) to the mainframe (1)
with bolt (12), flat washer (10). When folding it,
take off the knob (15) and fold the slide rail (22),
then fix it with the knob (15).
FUNCTIONAL BUTTON:
MODE
• - Push down to select functions.
• - Push down and hold for 2 seconds to reset all
functional value.
FUNCTIONS AND OPERATIONS
1. SCAN: When in SCAN position, the meter will
rotate through the following functions: time,
count, total count, calorie, count/min. Each
display will be hold for 6 seconds.
2. TIME: Count the rowing time from exercise
start to end.
3. COUNT: Count the rowing strokes from start
to end.
4. TOTAL COUNT: Count the total rowing strokes
from start to end.
5. CALORIES: Count the total calories from ro-
wing start to end.
6. COUNT/MIN: Display current rowing strokes
per minute, or the frequency per minute.
7. AUTO ON/OFF & AUTO START/STOP.
STEP 5 - (F):
The Rowing machine could be folded if you do not
use it. First take off the knob (15), knob (2) and
flat washer (35), then fold the slide rail (22) and
protective guard (28) as the diagram shown. At
last fix the knob (2) and flat washer (35) to the
mainframe (1) and protective guard (28).
