SPM AIR14-01, Быстрый старт

Страница: 10 / 12

10 11
s p m i n s t r u m e n t . c o m | i n f o @ s p m i n s t r u m e n t . s e
CAUTION : The lid and antenna cable should be handled with care.
The antenna cable connected to the lid cannot be reassembled.
Do not disconnect the antenna cable from the circuit board.
0.5 Nm
0.5 Nm
REPLACING battery
When replacing the battery, appropriate ESD protection measures must be
taken.
1. Loosen the four screws and carefully position the lid so it does not interfere
with the battery replacement. The lid is attached to the antenna cable that
is attached to the circuit board at the other end.
2. Loosen the two screws and remove the battery cover.
3. Remove the battery and disconnect the plug.
4. Connect the plug and insert the new battery (18572).
5. Screw on the battery cover. Tightening torque: 0.5 Nm.
6. Put the O-ring in place and screw on the lid. Tightening torque: 0.5 Nm.
7. Go to
Notifications in Condmaster.NET and select Confirm battery change
for the sensor. For further information, see section Confirm Airius battery
replacement in the Condmaster.NET User Guide .