If the dryer will not run:
+
First ensure that the breaker supplying the dryer is operational. If it is, disconnect
the power and remove the dryer cover. Taking suitable precautions to avoid shock
hazard, reconnect the power and check for voltage at the terminal block. Verify
that connections are made correctly.
The dryer cycles by itself or runs constantly:
+
Ensure that there is no obstruction on or in front of the IR sensor. Clean any dirt or
debris of
f the sensor lens. If problem persists, replace sensor.
The dryer makes a loud noise and does not run for a complete cycle:
+
Ensure that the supply voltage is correct. Dryer will make a loud humming noise
if the input voltage is too high. Verify voltage requirement on unit rating label and
correct supply as required. (If circuit board module has been damaged, replace it
and the infra-red sensor module.)
The dryer runs but air stream is low pressure and/or low velocity:
+
Ensure that the supply voltage is correct. Dryer will run weakly if the input voltage
is too low. Verify voltage requirement on unit rating label and correct supply as
required.
initial installation
troubleshooting
We are always looking to improve. If these steps
did not solve your problem please contact us
and we will endeavor to help.
Tel: 310 410 5008
Email: [email protected]
TSL.C.060 CHANNEL HAND DRYER 19
