6
RackPack: Transient Designer
Fitting A Module
The fitting and/or exchange of modules should only be carried out by
qualified persons. Please read the manual of the RackPack frame. It
contains all information needed to fit a module as well as all safety
and notes and warnings. If you don‘t have the manual at hand, you
can download it like all SPL product manuals from our website http://
www.soundperformancelab.com.
Symbols And Notes
IN THIS MANUAL A LIGHTNING SYMBOL WITHIN A TRIANGLE WARNS
YOU ABOUT THE POTENTIAL FOR DANGEROUS ELECTRICAL SHOCKS
– WHICH CAN ALSO OCCUR EVEN AFTER THE MACHINE HAS BEEN
DISCONNECTED FROM A POWER SOURCE.
AN EXCLAMATION MARK (!) WITHIN A TRIANGLE IS INTENDED TO
MAKE YOU AWARE OF IMPORTANT OPERATIONAL ADVICE AND/OR
WARNINGS THAT MUST BE FOLLOWED. BE ESPECIALLY ATTENTIVE TO
THESE AND ALWAYS FOLLOW THE ADVICE THEY GIVE.
The symbol of a lamp directs your attention to explanations of impor-
tant functions or applications.
Attention
Do not attempt any alterations to this machine without the approval
or supervision of SPL electronics GmbH. Doing so could nullify com-
pletely any and all of your warranty/guarantee rights and claims to
user support.
The scope of delivery comprises:
• The module
• This manual
• A flat ribbon cable to connect and a jumper connector to configure
two Transient Designer modules for LINK mode.
• Two Philips screws to mount the module to the back panel (if mo-
dule is delivered separately from the frame). Further screws needed
for mounting the module remain when you remove front and rear
covers from the RackPack frame.
Hook Up
Scope Of Delivery
