HEATER SWITCH & QUIET (Q) MODE SWITCH
Heater Switch ON/OFF & Quiet Mode Switch (Factory default setting Heater “ON” / Quiet “OFF”)
8
3. Remove the (2) security screws from the unit, using the service tool (fig 8A).
4. Remove the (1) screw from back of unit, using the + screw driver (fig 8B).
5. Lift the front cover off the unit (fig. 9).
8A
9
1
ATTACHING UNIT
Reposition the front cover on the unit.
Refix the 2 cover security screws into the bottom of the front cover (fig. 8A).
Refix the cover screw situated in the base of the dryer (fig. 8B)
Reposition the unit on the wall mounting bracket and insert and tighten one security screw into the bottom
of front cover (fig. 7~7A).
Test the unit for correct operation. The LED light on the cover should flash 3 times with a red light after
the power supply has been correctly connected and followed by continuous light white LED.
Note: If the LED light remains off, the unit must be refitted correctly.
9A
6. To turn off or turn on heater, use the left switch shown in fig. 9A.
7. To change Quiet mode, use the right switch shown in fig. 9A.
2
1. Remove the one security screw seated on the bottom surface from the unit, using the service tool (fig. 2).
7
EN
The unit has a built in UV-C lamp, avoid exposure to direct germicidal UV rays.
Heat
ON
ON
1
Q Mode
ON
Heat
ON
ON
1
ON
1
Q Mode
ON
2. Lift the unit off the wall mounting bracket (fig. 8).
Note: Ensure the LED light on the front of the unit is OFF before opening the front cover, if the LED light
is still ON, wait until the light goes off.
ON
1
8B
