Phonitor 2
7
Be very careful to check that the rear chassis power selection is set
correctly before using the unit (230 V position: 220-240 V/50 Hz, 115 V
position: 110-120 V/60 Hz)!
When in doubt about a source, contact
your dealer or a professional electrician.
Read page 15 for instructions on how to set the correct voltage.
Before connecting any equipment make sure that any machine to be
connected is turned off. Follow all safety instructions from page 5.
Place the unit on a level and stable surface. The unit’s enclo-
sure is EMC-safe and effectively shielded against HF interference.
Nonetheless, you should carefully consider where you place the
unit to avoid electrical disturbances. It should be positioned so that
you can easily reach it, but there are other considerations. Try not to
place it near heat sources or in direct sunlight, and avoid exposure to
vibrations, dust, heat, cold or moisture. It should also be kept away
from transformers, motors, power amplifiers and digital processors.
Always ensure sufficient air circulation by keeping a distance of 4-5
cm/2 inches to other units and to the sides of the unit.
Before You Begin
Make sure the Volume control is turned hard left before you power up
the unit. Now control Volume. Note that too high levels can damage
headphones and hearing!
Hook Up
