MTC Mk2
MTC Mk2
2
3
Getting started
Read the safety instructions starting on page 11.
Make sure that the mains voltage of the MTC Mk2 mentioned in the specifications
(page 10) corresponds to the voltage of your region.
The power switch on the back of the MTC Mk2 must be in the off position.
(Off = O / On = I).
Connect the supplied power cord to the power connector of the MTC Mk2 and to a power
outlet.
If the supplied power cord does not match your mains socket outlet, please contact your dealer.
The devices that are to be connected to the MTC Mk2 must be be switched off.
Connect the outputs of your analog sources to the analog inputs of the MTC Mk2. Please
use appropriate audio cables (TRS, RCA).
Audio cables not included in the scope of delivery.
Connect audio cables between the MTC Mk2 and following amplifiers or active monitors
(XLR, TRS).
Audio cables not included in the scope of delivery.
Connect headphones to the headphone outputs of the MTC Mk2.
Warning: Never connect a mono jack cable to the front panel stereo jack. Make sure that the stereo jack is fully inserted,
otherwise a short circuit might damage the headphone amplifier.
Power on
Turn down the volume and the headphone volume of the MTC Mk2.
Switch on the power switch on the rear panel of the MTC Mk2 (On = I).
The Power LED and all activated switches light up.
Power off
Turn down the volume and the headphone volume of the MTC Mk2.
Switch off the power switch on the rear panel of the MTC Mk2 (Off = O).
The Power LED and all activated switches will no longer light up.
Power LED
Power supply
Power switch
Volume
Outputs
Headphone volume
Inputs
EN
DE
