P n e u m a t i c
R o t a r y H a m m e r D r i l l
2 2 4 0 4 0 0 1 0 , 0 0 3 0 , 0 0 4 0
M a s c h i n e n f a b r i k G m b H
Spitznas Maschinenfabrik GmbH, Fellerstr.4, D-42555 Velbert, Tel: +49(0)2052 605 0, Fax: +49(0)2052 605 29
, www.spitznas.de
Translation of the original manual,
compiled: 25.05.12
224040010_30_40_BA_en_Version_01
Page 4 of 13
Do not operate the tool if it is damaged, improperly adjusted or not completely
and correctly assembled.
Check air hose for damage.
Work with oleiferous air only.
Avoid sparks in hazardous environment - created by the drill. Always flush
material and drill for cooling with sufficient water during working.
Do not employ machines by excessive force. Their performance is better and
safer, if they work at the prescribed speed.
Check damaged parts.
Before using the machine, damaged parts or protective devices should be
carefully checked to make sure they work soundly and fulfil the designated
function. Check alignment, connections and attachment of moving parts. Also
check if parts are broken. Parts or protective devices that are damaged should, if
nothing else is mentioned in these operating instructions, only be exchanged or
repaired by qualified personnel. The same applies to defective switches and
valve triggers. If the machine cannot be switched on or off with the valve trigger,
it should not be used.
The use of other accessories, or other additional items than recommended in
these operating instructions, may include the risk of bodily injury.
Only operate the tool after a thorough training or under supervision of a trainer.
Never exceed the maximum operation pressure.
Follow the valid national provisions in the country of application.
ATTENTION! Never use the flexible hose as a lifting handle!
