2 WHILE USING THE HEATER
- Read all instructions before using this heater take care to ensure you fully understand
the instructions concerning electricity and fuel supply.
- Know how to start and stop the unit. Be quite familiar with the controls.
- Allow a minimum room size as listed in the technical specifications.
- Not for domestic use, space heating only.
- Local regulations should be followed as to the installation of industrial heaters.
- Do not operate the heater if it is damaged.
- Never leave the heater unattended whilst running.
- Permanent ventilation to the outside atmosphere must be provided. Allow 96 sq.cm for
every 1000W input divided equally between floor and high levels.
- Do not operate this heater in basements or below ground.
- Do not restrict under any circumstances either the inlet or outlet end of the heater.
- The heater must not be used in close proximity to combustible or flammable materials.
- The heater must operate in a space with clearance of 1m above and behind and 600mm
on the sides. A guard must be placed 900mm away from the heater outlet to prevent the
approach of combustible materials.
- Always use the handle to move the heater after it has been operating as other parts of
the heater may be very hot.
- Use only clean filtered diesel or kerosene as fuel. Do not refill the fuel tank while the
heater is running or is still hot.
- Follow the maintenance procedures and fault-finding techniques outlined in the manual.
- To prevent injury always disconnect the power plug before disassembling any part of the
heater.
- Do not carry out temporary repairs on worn or damaged electrical cords and plugs.
- Have worn, cut or damaged cords and plugs replaced by an authorised service person or
electrician.
- Do not pull on the electrical cord in order to unplug the unit.
- Do not use this heater in the rain or when it is at risk of being sprayed with water.
3 ELECTRICITY SUPPLY
- The JETFIRE range of heaters is designed to run off 230V Single-Phase 50Hz electrical
supply. The unit should be plugged into a 10A outlet.
- The appliances must be earthed.
- If the Plug needs to be replaced to suit local requirements a qualified electrician should
carry out the replacement taking care to earth the unit and maintain the correct phase
connection as per the wiring diagram.
4 FUEL SUPPLY
- Please only use the following fuel types in the heater:
Kerosene with viscosity of 1.3 cSt or Diesel with viscosity of 1.5 cSt.
Содержание JETFIRE DI16
Страница 8: ...Figure B Figure A Figure G Figure H...
