Customer Service 1-888-707-1880
Dyaco Canada Inc. 2020
Email: [email protected]
26
CUSTOM PROGRAM
You can build your own custom program by following the instructions below.
1. Using the Program button, select Custom and then then press the Enter button to begin
programming
2. Enter your name in the Dot Matrix Message Center, the letter “A” will be blinking. Use the
Up/Down buttons to select the appropriate first letter of your name (pressing the Up button
will switch to the letter “B”; pressing the Down button will switch to letter “Z”). Press Enter
when the desired letter is displayed. Repeat this process until all of the characters of your
name have been programmed (maximum 7 characters). When finished press Stop.
3. If there is a program already stored in Custom, you will have an option to run the program as
it is or delete the program and build a new one. The Dot Matrix Message Center will ask: Run
Program? Use the Up/Down arrows to select “Yes” or “No”. If you select No, you will then be
asked if you want to delete the currently saved program. It is necessary to delete the current
program if you want to build a new one.
4. The Dot Matrix Message Center will ask you to enter your Age. You may enter your age,
using the Up/Down buttons, then press the Enter button to accept the new value and
proceed on to the next screen.
5. You are now asked to enter your Weight. You may adjust the weight value using the
Up/Down buttons, then press Enter to continue.
6. Next is Time. You may adjust the time and press Enter to continue.
7. Now you are asked to adjust the Max Resistance Level of the program, press Enter when
resistance has been selected.
8. Now the first column will be blinking and you are asked to adjust the resistance level for the
first segment (SEGMENT > 1) of the workout by using the Up button. When you finish
adjusting the first segment, or if you don’t want to change, then press Enter to continue to the
next segment.
9. The next segment will show the same workload resistance level as the previously adjusted
segment. Repeat the same process as the last segment then press Enter. Continue this
process until all twenty-four segments have been set.
10. After saving the program the Dot Matrix Message Center says “New Program Saved” then
will give you the option to start or modify the program. Pressing Stop will exit to the start up
screen.
