Customer Service 1-888-707-1880
Dyaco Canada Inc. 2016
Email: [email protected]
8
ASSEMBLY
INSTRUCTIONS
!!ATTENTION: IMPORTANT UNPACKING INSTRUCTIONS.
PLEASE READ BEFORE UNPACKING YOUR FOLDING TREADMILL!!
Serious injury could occur if this folding treadmill is not unpacked properly.
There is a Velcro strap installed around the treadmill base that prevents the treadmill from
unfolding accidentally during shipping. If this strap is not removed properly the treadmill could
spring open unexpectedly and cause injury if someone is standing near the treadmill when the
strap is removed.
To ensure your personal safety during removal of the shipping strap please make sure the
treadmill is positioned flat on the ground, in the orientation it would be in if you were using
the treadmill. Do not turn the treadmill up on its side while removing the shipping strap. This
could cause the treadmill’s folding mechanism to spring open. If the end of the Velcro strap
(that you need to grab to remove it) happens to be under the treadmill deck, reach under the
deck to grab it, but do not tilt the treadmill up to gain access to the strap end.
Cut the banding straps with a short box cutter (razor knife); separate the carton from the one
underneath it by prying up on the staples (if applicable). Pull the carton over the treadmill
parts and locate the hardware pack. The hardware pack is separated into five sections; one
section containing tools and four sections labeled steps 1-4 which contain the hardware
needed for assembly of each step. The assembly steps below are numbered one through
four and correspond to the hardware in the numbered sections of the hardware pack.
Remove only the hardware for the step you are currently assembling to avoid confusion and
mix ups.
Then remove the treadmill from the carton and lay it on a level surface.
ASSEMBLY
TOOLS
#
131
. Combination M5 Allen Wrench
& Phillips Head Screwdriver
#
148
. Phillips Head Screwdriver
#
132
. M6 Allen Wrench