©2017 Spireon, Inc. All rights reserved.
FL12/12HP Installation
Additional Trailer Types Device Harness
Running (cont.)
PART 2:
·
Trim any excess length of wire in the device harness; do not just
coil it in the housing
·
Pull the red and black wires to the side
·
Fold the remaining wires over the outside of the wire harness and
wrap them with electrical tape making sure all ends are completely
covered
·
Connect the red and black wires from the device harness to the
corresponding wires in the power harness
CONNECTING TO POWER AND GROUND:
·
Using the pre-attached butt connector, connect the red wire from
the power harness to the red wire from the device harness
·
With the other butt connector, connect the black wire from the
power harness to the black wire from the device harness
·
Strip the ends of the blue, brown and white wires in the power
harness and crimp a ring terminal onto each of them
·
Remove the nut on the terminal for pin #1 in the j560 (ground terminal) and connect the ring terminal
from the power harness’ white wire
·
Remove the nut on the terminal for pin #6 in the j560 (tail/license plate lamps) and connect the ring
terminal from the power harness’ brown wire
·
Remove the nut on the terminal for pin #7 in the j560 (AUX/ABS) and connect the ring terminal from
the power harness’ blue wire
POWER HARNESS DIAGRAM:
IMPORTANT NOTE:
J560 pins #6 and #7 must
be live and both wires in
the power harness must be
connected.
CAUTION:
The j560 pinout in the power
harness diagram is a front
view. Be sure the terminals you
connect to correspond to the
correct pins.
REMEMBER:
When covert mounting an FL12,
it is important that the antenna
side of the device has a clear
view of the ground, with no
metallic obstructions in its line
of sight.
To Device
Harness
