9
INSTALLATION
Fixing
There are 8 fixing screw positions, located as follows.
(A) – 2 in each side trim of the Grill opening
(B) – 2 in each side trim of the Oven opening
Make sure the appliance is fully home in the cabinet/aperture. Open the Oven door and fix
the screws in position. Finally open the Grill door and fix the screws in position.
Connection
Gas Connection - The gas connection is made to a 10mm compression fitting (Nut and
olive supplied) on the underside of the appliance. Prior to connection remove the plastic
protection plug from the fitting. It is recommended that the cooker be connected by copper
pipe, rubber tubing MUST NOT be used.
Electrical Connection – Ensure that all electrical cables and wires are routed well clear of
any heat source, including this appliance. The plug and socket must be accessible after
installation.
MAINTENANCE & SERVICING
This appliance needs little maintenance other than cleaning. All parts should be cleaned
using warm soapy water. Do not use abrasive cleaners, steel wool or cleansing powders.
When cleaning the burner ring it is essential to ensure that the holes do not become
blocked. The control knobs are a push fit and can be removed for cleaning.
ALL SERVICING MUST BE CARRIED OUT BY AN APPROVED COMPETENT PERSON.
BEFORE ANY SERVICE WORK IS STARTED, THE APPLIANCE SHOULD HAVE BEEN
LEFT TO COOL AND BE DISCONNECTED AT THE MAINS SOCKET. AFTER EACH
SERVICE THE APPLIANCE MUST BE CHECKED FOR GAS SOUNDNESS.
1. Disconnect from gas supply
Lift and remove the bottom plinth to gain access, then disconnect the gas supply.
2. Remove appliance from housing
Disconnect from gas supply (1). Open the grill door and remove the 2 screws from
the top of each side trim. Open the oven door and remove the 2 screws from the
bottom of each side trim. Carefully slide the appliance out one third and check for
any possible snagging of wires or pipes. If OK, lift appliance out onto a suitable
surface.
IMPORTANT
•
This appliance MUST be earthed
•
After installation the appliance must be tested for soundness
•
The gas supply input pressure to which this appliance is connected MUST not
rise or fall by more than 2.5mbar from nominal when ALL appliances connected
to the supply are operated simultaneously. If this appliance is not installed in
accordance with the instructions and tolerances detailed herein, we the
manufacturer can not be held responsible for any problems that occur, or poor
performance that is perceived/witnessed.
Содержание Country Leisure OP96000NG
Страница 2: ...2 ...
