Spinfire Pro 1, Руководство пользователя

Страница: 3 / 21

Page 3 Manual Revision 4.1.2
BEFORE FIRST USE
To protect the machine in transport, the internal pivot plate may have been
secured to prevent it from moving. Please remove any bolt(s) or cable tie(s)
prior to turning the machine on. You will normally find indicators (tags, stickers
or ribbons) helping you locate these before use, although sometimes they are
removed by the distributor during testing. If you receive a HCAL error when
you first turn on your machine, it is most likely because you have not correctly
completed this step. If your pivot plate was secured with a bolt, please keep
this with your box in case you need to ship the machine back for repair (it can
be re-inserted).
There is also a 3 position master power switch under the machine which is
turned off for transport. This will need to be turned on before you can power
on the machine (please turn this off after each use). The 3 positions are:
O Off
I Internal Battery
II External Battery or AC Adaptor
ASSEMBLY
To assemble your machine, first simply remove it from the box. To do this,
start by removing the hopper, followed by the machine. You can safely pick up
the machine by placing one hand inside the mouth at the front and using the
handle located at the rear of the machine above the control panel.
You should find this manual, a charger and the carousel in the box. If you
have ordered an external battery, AC adaptor or fast charger, they may also
be in the box. The carousel is the white 5 fingered device which stirs the balls
when they are sitting in the hopper. You need to attach this to the top of the
machine on the rod, noting the flat side of the rod needs to align with the hole
in the carousel. If you cannot insert the carousel due to an obstruction, you
may need to turn the machine on and rotate the rod to find a suitable location
to attach the carousel. You can do this by pressing the
Feed Start/Pause
button. Never bend the wire which floats above the drop hole, as this can
result in ball jams. It is also possible that the carousel may already be
attached when you receive your machine, so nothing will need to be done.
You can attach the hopper either upright for play mode, or upside down for
portability/storage (note you can remove the carousel too if you need to). To
attach the hopper, simply align it correctly and then push down on it until it
locks into place.