Spinfire Pro 1, Руководство пользователя

Страница: 12 / 21

Page 12 Manual Revision 4.1.2
*Settings may vary slightly between machines, please alter accordingly. This
also assumed the machine is set up at the baseline in the centre of the court.
Your machine can shoot balls to a single spot on the court, or you can add
oscillations (horizontal, vertical or two line drill) to add more variation.
TENNIS BALLS
Your machine can hold 200 balls. Whilst the hopper can possibly take a larger
quantity than this, we recommend you restrict it to 200 balls, which puts less
weight on the carousel motor.
We strongly recommend the use of pressureless balls, preferably from a
reputable brand. Balls can contain an oily coating in the felt which can cause
damage to the throwing wheels rendering them useless. Please choose
carefully when determining which balls to use in your machine. We
recommend the use of Spinfire Juice balls or a brand thoroughly tested and
recommended by your distributor (we do not recommend mixing brands).
Pressureless balls will also allow your machine to perform at its best. Each
ball will have a consistent bounce allowing you to consistently hit the spots on
the court that you want. Normal pressurized balls go flat quickly when used in
conjunction with a ball machine.
Low Compression Balls
Our machine can handle both orange (stage 2) and green (stage 3) low
compression balls. It cannot work with red (stage 1) balls due to their larger
size.
HIDDEN FEATURES
Manual Mode
If you experience any alignment (eg, shooting too far to the right) or
initialization (HCAL or VCAL errors) issues, it is likely you can resolve them by
starting the machine in manual mode. To do this, please follow these 3 steps:
1. Make sure your machine is turned off (you may need to use the master
switch under your machine).
2. Manually move the internal mechanism of your machine to the lowest
possible elevation and to the center of the opening.
3. With the master switch on, hold both the power and menu buttons at
the same time for 5 seconds to turn on your machine. The LCD should
display a message to let you know you have entered “manual mode”.
The above steps can be seen in this video: https://goo.gl/C6zB3J
If this resolves your problem, then you can continue to use your machine this
way until a permanent solution can be obtained from your Spinfire dealer.
Please note that this solution relies on you performing step 2 above correctly.
If you do not set the machine to the correct position before turning on the
machine, you will find that the calibration may be off target. You will either