5176-010 ADJUSTABLE SINGLE BAR TRAINER
Assembly Instructions
Page 10 of 14
1. Make sure you assemble the quick links
(3)
in the proper direction
(always tighten downward)
like
Figure
7
below.
2. Adjust the turnbuckles
(8)
to medium length to enable the cables to be adjusted easily like
Figure
10
below.
Do not close the floor attachment quick links, so that the threaded socket adaptors (6)
can be set up.
3.3 Assembling the cables
The assembly and set-up of the cables requires a minimum of two qualified persons.
Do not attempt the assembly and set-up of this apparatus alone!
1. Identify the location of each cable using
Figure 2
(on page 5) and the general view (on page 4).
2. Once the location of each cable is properly identified,
attach the ends of the cables on all of
the
uprights, using the large opening quick links (3), respecting the precautions about
assembly and tightening directed above.
3. Hook the turnbuckles
(8)
of the cables
(1)
to the rear threaded socket adapters
(B),
then set the
chain lengths.
Figure 11 -
quick link (3) / load binder (4) assembly
Figure 7-
quick link (3) / upright assembly
Figure 8 & 9 -
quick links (3) / chain assembly
Figure 10 -
quick link (3) / turnbuckle tie (8) assembly
