SPIEGEL 60609, Руководство по эксплуатации

Страница: 33 / 86

SPIEGEL 60609 LIMITED EDITION COMPUTERIZED SEWING MACHINE
~25~
Lower (Bobbin) Threading
WARNING —
Always switch off the machine power before performing lower threading.
CAUTION —
The 60609 swing machine uses a BO-103(Z) style bobbin. Use of any
unapproved bobbin may damage the machine or result in poor performance.
Always stop sewing before winding the bobbin.
The needle must be raised to its upper position before inserting or removing the bobbin.
Perform the following steps to insert the bobbin:
1. Remove the accessories box and open the hinged cover
below the needle area. Remove the bobbin case by
pulling the attached lever. Hold the bobbin case so the
thread unwinds in the direction shown and put the
bobbin in the bobbin case.
2. Pull the thread into the notch.
3. Draw the thread under the tension spring.
4. Draw the thread out from the slot on the end of the
spring and pass it through the bobbin case thread
guard. Allow about 4 inches of thread to hang freely
from the bobbin.
5. Insert the bobbin case fully into the machine as shown
and release the latch. Make sure the metal finger fits
into the notch at the top of the race cover. You should
hear a loud “click” when the bobbin seats properly.
Do not operate the sewing machine with the bobbin installed unless you hear the bobbin
locking mechanism click, indicating it is seated properly.
NOTE
NOTE
2
3
4
1