Setup
1.
Firmly press the thumb tab and pivot the upright up until it
locks in a nearly vertical position.
2.
Insert the handles into the stem until the lock pins are visi-
ble in the holes in the stem.
3.
Open the quick-release lever. Depress the lock pin on the
stem, and slide the stem up until the lock pin is visible in
one of the three holes in the upright. When the stem is at
the desired height, close the quick-release lever so it is snug
against the upright. If the quick release is not snug, see
ADJUSTING THE QUICK RELEASE on the back of this
manual.
Before using the scooter, make sure that the scooter is set up
as described and that all parts are securely tightened.
The decal shown at the right has been placed on the scooter.
If the decal is missing or illegible, please call our Customer
Service Department toll-free at 1-800-999-3756, Monday
through Friday, 6 a.m. until 6 p.m. Mountain Time, to order
a free replacement decal. Apply the replacement decal in the
location shown.
Storage
1.
Open the quick-release lever. Depress the lock pin on the
stem and slide the stem down into the upright. Close the
quick-release lever.
2.
Depress the lock pins and remove the handles from the
stem. Press the handles into the storage clip on the upright.
3.
Pull the thumb tab and pivot the upright down until it locks
in the horizontal position.
Thumb Tab
Thumb Tab
Storage Clip
Hand
Brake
Stem
Quick Release
Handle
Handle
Upright
Hand Brake and Cable are not shown.
Lock Pins
Lock Pin
Upright
Front
Left Side
Right Side
Groove
