Part No. 168689 R0101A
Printed in China © 2001 ICON Health & Fitness, Inc.
Adjusting the Quick Release
If the quick release doesn’t hold the stem snug in place, you
will need to adjust it.
Open the quick-release lever. Turn the adjustment nut clockwise
one half turn while keeping the lever from turning. Close the
lever. Repeat this procedure until the stem is held snug in place.
If the quick release is too snug to close, you will need to adjust it.
While the quick-release lever is open, turn the adjustment nut
counterclockwise one quarter turn while keeping the lever from
turning. Close the lever. Repeat this procedure until the stem is
held snug in place and the quick release is closed.
Adjustment
Nut
Open
Close
Lever
Quick
Release
Hand Brake Maintenance
Refer to inset drawing 1. Locate the adjustment barrel (B) and
the lock nut (A) on the hand brake. Turn the lock nut (A) coun-
terclockwise to loosen it. Next, turn the adjustment barrel (B)
counterclockwise a few turns. Then, turn the lock nut (2) clock-
wise to retighten it. Repeat until the hand brake is properly
adjusted.
If the movement of the hand brake needs to be further adjusted,
the lower end of the brake cable can be adjusted. Using an allen
wrench, remove the indicated union bolt set (36). Next, remove
the rear deck screw (32) and lift off the deck (1).
Refer to inset drawing 2. Locate the adjustment barrel (C) and
the lock nuts (D and E) near the end of the brake cable. Using a
small open-end wrench, turn the outer lock nut (E) counter-
clockwise to loosen it. Next, turn the adjustment barrel (C)
counterclockwise a few turns. Then, turn the inner lock nut (D)
clockwise to tighten it.
Reattach the deck (1) with the rear deck screw (32) and the
union bolt set (36).
A
1
2
B
32
1
36
36
C
D
E
